Raypak RP2100 ASME Operations Instructions download pdf (Page 40)

REMOTE CONTROL INSTALLATION AND OPERATION

CAUTION: Before installing remote controls to the AFT thermostat model heaters, read the following:

The digital thermostat model is remote-ready in most cases. The digital liquid crystal display (LCD) shows the

actual pool temperature, operating status, and service codes (See examples below). The touch pad on the con-

rol panel allows you to select the desired pool or spa temperature. It also indicates when a remote system is

controlling the heater by displaying Remote in the display. When connecting the heater to a remote system,

identify whether it is a two- or three-wire remote system. Select the appropriate instruction listed below to prop-

erly install the remote to the heater.

OFF Mode

Heating in the POOL Mode

Heating in the SPA Mode

Remote Mode

REMOTE OPERATION

The AFT model heaters are equipped with the ability

to work with external remote controls. The supplied 7-

pin remote wiring connector supplies power out to

either a toggle switch or the switch contacts of a third

party remote. The remote works by either making or

breaking the circuit created by the remote wiring.

Typically, a remote does not supply power to the

heater, it only provides a switching function to turn the

heater On or Off. If your remote is supplying its own

voltage to the heater, it will not work with this

heater and may damage the digital circuit board.

For operation of the heater using the onboard thermo-

static controls with a time clock, see the “Time Clock /

Fireman’s Switch” section.

Note: Electrostatic Discharge (ESD) damage can be caused by

direct or indirect contact with the wiring or circuit board. When

one walks to the heater area, an electrostatic charge accumu-

lates on the body. Contact of a finger allows the body to dis-

charge, possibly causing device damage. This damage can be

limited if the service person discharges himself, following ESD

preventive/removal practices, and holds on to the heater enclo-

sure for 5 seconds before proceeding.

Pool Common

(BLK/ORN)

Spa Common

(ORN/BLK)

24VAC HOT

(BLU)

7-PIN Remote

Interface Harness

ACTIVATING THE REMOTE

To activate or deactivate the remote function, follow

these steps:

Press and hold the UP and DOWN arrow buttons for

3 to 5 seconds.

The second line of the display will alternate even

when the unit is off (“No Demand”).

NOTE: When in remote operation, the keypad

mode and temp buttons are disabled.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Comments to this Manuals

No comments

Raypak RP2100 ASME Operations Instructions Page 40

Comments to this Manuals

Related products and manuals for Above ground pool accessories Raypak RP2100 ASME