Raypak WH 0195A User Manual download pdf (Page 26)

Replacement Parts

Any part returned for replacement under standard

company warranties must be properly tagged with

RAYPAK return parts tag, completely filled in with the

heater serial number, model number etc., and shipped

to the Company freight prepaid.

If determined defective by the Company and within

warranty, the part will be returned in kind or equal sub-

stitution, freight collect. Credit will not be issued.

RAYPAK, INC.

2151 Eastman Avenue

Oxnard, CA 93030

Circulator Replacement

1. Shut off electrical power to the heater.

2. Shut off water supply and open drain valve to

remove water in the piping at the pump level.

3. Disconnect wiring and conduit connections to the

pump.

4. Remove the nuts and bolts at the inlet and outlet

flanges. Remove old gaskets.

5. Remove the pump.

6. Reverse the above procedure to re-install. Use

new gaskets and make sure they are seated prop-

erly when tightening the nuts and bolts.

CAUTION: To avoid damage to electrical compo-

nents keep water from getting into the control

compartments and gas valve.

NOTE: To supply the correct part it is important that

you state the model number, serial number and type

of gas when applicable.

1 2 ... 21 22 23 24 25 26 27 28

No comments

Raypak WH 0195A User Manual Page 26