Raypak HI DALTA HD101 User Manual download pdf (Page 38)

Check the Gas Supply Pressure

1. Slowly turn on main gas shut-off valve.

2. Read the gas supply pressure from the manome-

ter; minimum supply pressure is 4 in. WC,

recommended supply is 7 in. WC for natural gas

(

minimum 11.0 in. WC for LP gas).

3. If pressure is > 14 in. WC, turn off the valve.

4. Check if the service regulator is installed and/or

adjust the service regulator.

Start-Up

Blower Adjustment

1. A nylon tee fitting is connected with hoses in-line

with the air pressure switches. Disconnect the

plugged side and connect a manometer.

2. Close the gas valve.

3. Turn power on.

4. During startup or Lo-Fire, the air pressure should

read 0.5±0.05 in. WC. During Hi-Fire, the reading

should be between 0.9 in. WC and 1.0 in. WC. If

these are not the obvserved manometer readings,

adjust the air shutter on the blower to attain the

correct values. (See Fig. 4, air shutter adjustment,

on page 7).

5. Turn power off.

6. Reinstall rubber plug on tee.

Main Burner Adjustment

1. Turn off unit.

2. Open manual firing valve.

3. Turn on the unit, wait 15 seconds, and the igniter

should glow. There’s a sight glass to check igniter

at both ends of the heater. Gas valve should be

open after 45 seconds.

4. If burner does not light on first trial. It will retry, up

to 3 times.

5. Main burner ignition – check manifold gas pres-

sure at gas valve manifold pressure tap. (See

Table O).

6. If the pressure reading differs by more than the tol-

erance given, adjust the gas valve accordingly.

See gas valve adjustment section below for

instructions.

Gas Valve Adjustment

Honeywell Gas Valve

1. While the heater is running, remove plastic cap

located behind ON/OFF knob.

2. Locate the HI or LO screw to adjust.

3. Using a small flat screwdriver, turn clockwise to

increase and counterclockwise to decrease mani-

fold pressure. See nominal gas valve manifold

settings in Table O above.

4. Replace plastic cap when pressure is set.

White Rodgers Gas Valve

1. While the heater is running, locate the HI or LO

cap located adjacent to ON/OFF switch.

2. Remove the appropriate cap.

3. Using a flat screwdriver, turn clockwise to increase

and counterclockwise to decrease manifold pres-

sure. See nominal gas valve manifold settings

above.

4. Replace cap(s) when pressure is set.

Invensys (Model HD401 Natural

Only)

1. Turn heater off.

2. Locate and remove the Torx tamper resistant

screw. (Shown in Fig. 31)

Table O: Gas Valve Pressures

Firing

Stage

Gas Valve

Gas Type

Natural

+/- 0.1"WC

LP/Propane

+/- 0.1"WC

Hi-Fire

Invensys 3.3" WC

Honeywell or

White-Rodgers

3.1" WC 9.6" WC

Lo-Fire

Invensys 1.2" WC

Honeywell or

White-Rodgers

1.4" WC 3.6" WC

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

Comments to this Manuals

No comments

Raypak HI DALTA HD101 User Manual Page 38

Comments to this Manuals

Related products and manuals for Water boiler Raypak HI DALTA HD101