INSTALLATION & OPERATING INSTRUCTIONSCATALOG NO. 6000.57F Effective: 12-02-08 Replaces: 5-20-08 P/N 241086 Rev. 7WARNING: If these instruction
Wiring Diagrams—182-260 H4/WH1 (Atmospheric)California Hot Water Supply, Inc. (800) 249-724410
181-261 H4/WH1 (Low NOx)California Hot Water Supply, Inc. (800) 249-724411
Dimensional Data181 18.13 12.38 7.88 4.25182 18.13 12.38 7.88 4.25260 18.13 12.38 7.88 4.25261 18.13 12.38 7.88 4.25330 17.50 15.75 7.63 6.00331 17.50
Sequence of OperationOn call for heat, the D-2 Power Vent fan (and appli-ance pump) start. When the flow switch circuits close,the ignition system con
123456789101112131415Call Out Description 181-261 331-4011 Power Vent Relay 008784F 008784F2 Power Vent Blower 008156F 008156F3 Power Vent NO Pressure
California Hot Water Supply, Inc. (800) 249-724415
www.raypak.com Raypak, Inc., 2151 Eastman Avenue, Oxnard, CA 93030 (805) 278-5300 Fax (805) 278-5468Litho in U.S.A.California Hot Water Supply, Inc.
Rev. 7 reflects the following: Changes to: The text in paragraph one of the Venting section on page 8.California Hot Water Supply, Inc.
Warnings 4Pay Attention to These Terms 4Receiving Equipment 5General Specifications 5Installation 5Mounting the Assembly 5Wiring a Power Vent Assembly
DANGER: Indicates the presence of immediate hazards which will cause severepersonal injury, death or substantial property damage if ignored.WARNING:In
Receiving EquipmentOn receipt of your equipment it is suggested that youvisually check for external damage to the carton. If thecarton is damaged, it
7. Mount the Power Vent on the outer top.8. Route the conduit harness of the Power Vent thruthe outer top hole, around the adapter towards theback of
U.S. Installations1Canadian Installations2AClearance above grade, veranda, porch, deck, or balcony1 ft (30 cm) 1 ft (30 cm)BClearance to window or doo
Wiring a Power Vent Assemblyto an Appliance with IIDIgnitionVentingThe vent pipe must be the same size or one size larg-er than what is indicated. The
LEFT SIDEThe D-2 Power Vent assembly includes a wire harness, shown in Fig. 6 below, which provides quick connec-tions with the respective controls in
Comments to this Manuals