Raypak 6100 Owner's Manual

Raypak® Swimming Pool Heat PumpOWNER’S MANUAL This manual should be maintained in legible condition and kept adjacent to the heat pump or in a saf

7C. Unplug Condensation Drain Holes - The heat pump extracts humidity from the air as it passes through the coil, similar to the way a cold drink outs

8B. UNIT IS NOT RUNNING• Is the control panel Power lamp ON? If not, the circuit breaker may be shut OFF or tripped. Reset the breaker by switching it

9Plumbing DiagramsFor systems with pumps of less than 2 HP (under 80 gpm), no external bypass is required. Connections are 2-inch unions. Plumb the he

10

iPRODUCT SAFETY SIGNS AND LABELSThis manual, as well as the pool/spa heat pump itself, contains ANSI-approved product safety signs and labels. Please

iiSwimming Pool Heat PumpOWNER’S MANUAL - Models 5100 and 6100 CONTENTSIntroduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1IntroductionThis pool heat pump is an electromechanical machine that incorporates a pressurized refrigerant gas in a sealed system. ONLY trained and

2Situate the pool heat pump carefully to minimize installation costs while providing maximum efficiency of operation, and to allow adequate service ac

3III. Water ConnectionsThe heat pump inlet and outlet connections are NOT interchangeable. They must be connected as instructed below.1. Connect the

4NOTE: The heat pump will not run when the Remote position is selected and there is no remote control system attached.Defrost Switch: Prevents heat pu

5NOTE: The heat pump will be OFF when the Remote position is selected on the Pool/Spa selector switch and there is no remote control system attached.4

6VII. Freeze ProtectionIf the heat pump is installed in a location subject to freezing conditions, it is important to protect the water circuit from f